Right-click the RAW drive to choose 'Format'. Go to This PC, My Computer or Disk Management, find the RAW drive. After you have successfully recovered data on the RAW drive, you can convert RAW to FAT32 by format without worrying about data loss. Step 2: Convert RAW to FAT32.

An alternate solution is to temporarily change the Replication to Asynchronous Mode and perform a rescan.Note: In most cases, data access to the volume can be manually enabled by performing the following steps:A. If the replication mode is Synchronous and a secondary RVG has been disconnected from the primary RVG, then the volumes residing within the primary RVG will remain RAW until the Secondary has been reconnected to the Primary and replication has been resumed. They should become available again once the RVGPrimary resource has been started.Note: The RVGPrimary resource is normally offline unless it is present on the primary site.4.

The backup copy of the boot sector is located at the last sector of a volume. The boot sector is located at the first sector of a volume. In some cases, the boot sector may be recovered by restoring the backup copy of the boot sector.Note: The boot sector should not be confused with the master boot record (MBR), which is located at the beginning of the disk. The NTFS boot sector is corrupt.

Ntfs Disk Shows As Raw